Fluke 5700A Series II User Manual

5700A/5720A Series II
Operators Manual
A-6
1802 Bad Boolean Selector
1803 NRMrngStby Encountered Error
1804 DCV Called For Non-DCV Range
1805 ACV Called For Non-ACV Range
1806 Bad ACV Frequency Range
1807 Hi Res Frequency Too High
1808 ACV Amplitude Correction Failure
1809 Cannot Phase Lock To Signal
1810 Bad Phase Quadrant
1811 Current Called for Non-Current Range
1812 Ohms Called for Non-Ohms Range
1813 Cannot Phase Lock, Output Not AC
1814 Cannot Phase Shift, Output Not AC
1815 Bad Wide Band Range
1816 Freq. Too High Even For Wide Band
1817 Illegal Current Output Location
1818 Output Current Out Of Tolerance
1819 Current Compliance Voltage Exceeded
1820 2-Wire Compensation Current Exceeded
1821 NRMbstcur Passed Bad Range
1822 5220 No Longer Connected
1823 5220 Detected Fault And Shut Off
1824 5205 No Longer Connected
1825 5205 Detected Fault And Shut Off
1826 5725 No Longer Connected
1827 14 Bit DAC Scaling Found Zero Output
1900-Level Faults: Non-Volatile Subsystem
1900 Could not Write Byte To EEPROM
1901 Checksum Error Reading EEPROM
1902 EEPROM Is Full
1903 Unknown Nonvolatile Constant Selector
1904 EEPROM Partition Is Full
1905 Could not Write Byte To 5725 EEPROM
1906 Checksum Error Reading 5725 EEPROM

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V