Fluke 5700A Series II User Manual

Appendices
Fault Codes
A
A-9
2513 Could not Cal 220 mV Gain S4
2514 Could not Cal 220V DC Offset
2515 Could not Cal 220V DC Rnet
2516 Could not Cal 220V DC Gain
2517 Could not Cal ACV Gain
2518 Flatness Cal: Main Sensor Fail?
2519 Flatness Cal: AC Cal Sensor Fail?
2520 Could not Cal Fine Tune (14 bit) DAC
2521 Could not Cal Fine Tune 15th bit Down
2522 Could not Cal Fine Tune 15th bit Up
2523 Could not Cal 2.2 mV/22 mV step 1
2524 Could not Cal 2.2 mV/22 mV step 2
2525 Could not Cal 220V AC Offset
2526 Could not Cal 220V AC Gain
2527 Could not Cal 220 mV Offset
2528 Could not Cal 1100V AC/DC Offset
2529 Could not Cal 1100V AC/DC Gain
2530 Could not Cal 220 µA DC Zero
2531 Could not Cal 2.2 mA DC Zero
2532 Could not Cal 22 mA DC Zero
2533 Could not Cal 220 mA DC Zero
2534 Could not Cal 2.2A DC Zero
2535 Could not Cal 220 µA DCI (Meas 1)
2536 Could not Cal 220 µA DCI (Meas 2)
2537 Could not Cal 2.2 mA DCI (Meas 1)
2538 Could not Cal 2.2 mA DCI (Meas 2)
2539 Could not Cal 22 mA DCI (Meas 1)
2540 Could not Cal 22 mA DCI (Meas 2)
2541 Could not Cal 220 mA DCI (Meas 1)
2542 Could not Cal 220 mA DCI (Meas 2)
2543 Could not Cal 2.2A DCI (Meas 1)
2544 Could not Cal 2.2A DCI (Meas 2)
2545 Could not Ext Cal 10K Ohm Std (Meas 1)

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V