Fluke 5700A Series II User Manual

5700A/5720A Series II
Operators Manual
A-8
2221 Invalid Decimal Number
2222 Invlaid Hexadecimal Block
2223 Invalid Hexadecimal Number
2224 Too Many Parameters
2225 Invalid Octal Number
2226 Too Many Characters
2227 Invalid String
2228 Invalid Register Address
2229 Invalid Cal Constant Name
2230 Remote Serial Port Dead
2231 IEEE488.2 Query After Indef Response
2300-Level Faults: Executive Subsystem
2300 Unknown Report Requested
2301 Unknown Report Device Requested
2302 Serial Port Timeout
2400-Level Faults: Real Time Clock Subsystem
2400 Cannot Install Interrupt Handler
2401 Unknown Interrupt Selector
2402 Bad Date & Cannot Be Set
2500-Level and 2600-Level Faults: Self Calibration Subsystem
2500 Invalid Cal Procedure Number
2501 Could not Ext Cal Gain
2502 Could not Ext Cal Ref
2503 Could not Ext Cal Neg
2504 Could not Cal Ratio
2505 Could not Cal Pos 11V or 22V DC Zero
2506 Could not Cal Neg 11V or 22V DC Zero
2507 Could not Cal Pos 11V or 22V DC Gain
2508 Could not Cal 6.5V or 13V Buf Ref
2509 Could not Cal 2.2V Zero
2510 Could not Cal 220 mV Gain S1
2511 Could not Cal 220 mV Gain S2
2512 Could not Cal 220 mV Gain S3

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V