Fluke 5700A Series II - Index

1
Index
—*—
*CLS remote command, 5-26
*ESE remote command, 5-27
*ESE? remote command, 5-28
*ESR? remote command, 5-28
*IDN? remote command, 5-30
*LRN? remote command, 5-32
*OPC remote command, 5-33, 5-66
*OPC? remote command, 5-33, 5-66
*OPT? remote command, 5-34
*PUD remote command, 5-35
*PUD? remote command, 5-36
*RST remote command, 5-37
*SRE remote command, 5-39
*SRE? remote command, 5-39
*STB? remote command, 5-40
*TST? remote command, 5-40
*WAI remote command, 5-41, 5-66
—5—
5100B Emulation Mode
Current Output Location, 5-70
Differences in the Ohms Function, 5-70
Entering Emulation Mode, 5-68
Exiting Emulation Mode, 5-69
Local to Remote Transitions, 5-69
Ohms Remote Program Modifications, 5-71
The 5720’s Display During Emulation, 5-69
5100B Emulation Mode, 5-69
5200A Emulation Mode, 5-72
Entering Emulation Mode, 5-68
Exiting Emulation Mode, 5-69
Overload Conditions, 5-74
Phase Lock Errors, 5-74
Programming External Sensing, 5-74
Rounding Numeric Entries, 5-73
Settling Times, 5-73
The 5720’s Display During Emulation, 5-69
Using Hard Switches to change Operating
Modes, 5-72
Voltage and Frequency Ranges, 5-72
5725A AMPLIFIER Connector, 3-12
5725A Amplifier Output, 4-37
—7—
732B Direct Voltage Reference
Standard, 1-6, 8-4
732B-200 Direct Volt Maintenance Program
(U.S.A. Only), 1-7
742A Series Resistance Standards, 1-7
742A Series Standard Resistors, 8-5
—A—
AC Current Output, 4-28
AC PWR INPUT Connector, 3-14
AC Voltage output, 4-25
Accessing the Fuse, 2-5
Accessories, 8-3
DC Voltage Reference Standard (732B), 8-4
Low Thermal EMF Test Leads, 8-4
Rack Mount Kits (Y5737 and Y5735), 8-4
Resistance Standards
(742A - 1 and 742A-10k), 8-5
RS-232C Null-Modem Cables (Y1702 and
Y1703, 8-4
Shielded IEEE-488 interface cables (Y8021,
Y8022, and Y8023), 8-4
Add/Subtract key, 3-9
ADJOUT? remote command, 5-17
Air filter, 2-4
Amperes key, 3-8