Fluke 5700A Series II - Page 335

Index (continued)
7
Status, checking
Event Status Register, 5-49
Bit Assignments for the ESR
and ESE, 5-49
Loading the ESR and ESE, 5-50
Reading the ESR and ESE, 5-50
Instrument Status Change Enable Register
Bit Assignments for the ISR, ISCR, and
ISCE, 5-51
Loading the ISCE, 5-52
Reading the ISR, ISCR, and ISCE, 5-52
Instrument Status Change Register, 5-51
Bit Assignments for the ISR, ISCR, and
ISCE, 5-51
Reading the ISR, ISCR, and ISCE, 5-52
Instrument Status Register, 5-51
Bit Assignments for the ISR, ISCR, and
ISCE, 5-51
Reading the ISR, ISCR, and ISCE, 5-52
Instrument StatusChange Enable Register, 5-51
Serial Poll status byte, 5-47
Service Request Enable Register, 5-48
Service Request Line (SRQ), 5-48
SRE, loading, 5-48
STBY remote command, 5-40
STOP_PR remote command, 5-40
Syntax, remote commands, 5-7
—T—
Terminators, remote, 5-9
Time, 4-9
Troubleshooting, 2-4
Turning on the Calibrator, 4-3, 4-4
Two-Wire Compensation Circuitry, 4-32
Two-Wire Resistance Connection, 4-32
—U—
UNCERT? remote command, 5-41
Uncertainty Specification, checking, 4-38
Uncertainty Specifications, displaying, 4-34
Unpacking, 2-3
Using an Auxiliary Amplifier, 4-36
UUT, Connections to the Calibrator, 4-12
—V—
Variable Phase Out BNC Connector, 3-12
Variable Phase Output, 4-34
Phase Controls menu, 4-34
Quadrature points, 4-35
Voltage
Guard, when to use, 4-15
Limits, setting, 4-51
Line, 2-6
Setting the output, 4-22
Voltage Guard Binding Post, 3-10
Voltage Guard Binding Posts, 3-12
Voltage Selection Switches, 3-14
Voltage Switch, 3-14
Voltage units key, 3-8
Volts key, 3-8
VOUT? remote command, 5-41
—W—
W Bnd key, 3-5
Warm Up, 4-4
WBAND remote command, 5-41
Wideband AC Module
dBm calculation, 4-33
Output, 4-32
use of W BND key, 4-32
Wideband AC Module (Option 5700A-03)
Calibrating, 7-18
Calibration, 1-7
Wideband AC Voltage Module (Option
5700A-03), 1-5
Wideband AC Voltage Output (Option
5700A-03, 4-32
WIDEBAND Connector, 3-10
Wideband voltmeter flatness test, 4-64