Chapter 8: Use Projects
Tutorial: Make a New Project
155
2-2. Optional: Enter the email address that the operator will use as
an ID to sign in to LinkWare Live.
2-3. When you are finished, tap DONE.
2-4. To go back to the PROJECT screen, tap the name of the
operator you want to use.
Step 3: Set up Tests for the Project
A project includes the tests and settings for the tests that are
necessary for a job. If you do not specify settings for a test, the
tester uses the default settings.
For this tutorial, your project will include tests for twisted pair
cable.
To set up a twisted pair test for the project
3-1 On the PROJECT screen, tap NEW TEST.
3-2. On the TEST SETUP screen, select and change the test settings
as necessary for a test on twisted pair cable. For information
about twisted pair test settings, see “Settings for Twisted Pair
Tests” on page 82.
3-3. When you have completed your selections for the twisted pair
cable test, tap SAVE on the TEST SETUP screen.
(continued)
To Next Page
Loading...
