Fluke DSX-600 - Import an ID Set into a Project; Delete an Imported ID Set

Chapter 8: Use Projects
How to Make ID Sets
169
If your project has both a Next ID set and sets with first and last
IDs, the % Tested value includes tests you saved with Next ID. For
example, if you have one Next ID set and one set with 10 IDs, and
you save 10 results with next IDs, the % Tested shows 50% (10
saved results divided by 20 IDs).
Import an ID Set into a Project
You can use LinkWare PC software to make ID sets, download
them to the tester, then import them into projects.
Note
ID sets that you download to the tester must have
the extension “.ids”.
To import an ID set
1 In LinkWare PC, select Utilities > DSX CableAnalyzer > Create
ID List to make an ID set and download it to the tester.
2 On the home screen, tap the PROJECT panel.
3 Make sure the correct project shows on the PROJECT screen. If
necessary, tap CHANGE PROJECT to select a different project.
4 On the PROJECT screen tap NEW ID SET, then tap IMPORT.
5 On the IMPORT CABLE ID screen, tap the ID set you downloaded.
6 Tap IMPORT.
Delete an Imported ID Set
If you go to the PROJECT screen and delete a cable ID set that you
imported into the project, the ID set is still available in the tester.
To delete an imported ID set from the tester
1 In LinkWare PC, select Utilities > DSX CableAnalyzer > Create
ID List.
2 In the Custom ID List dialog, click the Delete List On Tester
icon, select a list, then click OK.