Fluke DSX-600 - Tutorial: How to Use a Project for Tests

DSX-600 CableAnalyzer
Technical Reference Handbook
160
Tutorial: How to Use a Project for Tests
This tutorial assumes that you completed the tutorial “Make a
New Project” on page 152.
Figure 71 shows the minimum equipment necessary for this
tutorial.
Figure 71. Equipment for the Twisted Pair Project Tutorial
Step 1: Select a Project
If the correct project name does not show on the home screen,
tap the PROJECT panel, tap CHANGE PROJECT, tap the name of a
project, then tap DONE.
Step 2: Select a Test for Twisted Pair Cable
On the home screen, tap the test type panel, on the CHANGE
TEST screen (Figure 72), tap the test you made for twisted pair
cable, then tap USE SELECTED.
BA101.EPS
 Main and remote testers
 Two channel adapters
 Twisted pair cable
 AC adapters (optional)
A
C
D
B