DSX-600 CableAnalyzer
Technical Reference Handbook
192
If the first use was more than 6 months after calibration, the
Calibration Start Date is the date the tester was calibrated, plus 6
months. For example, if the tester was manufactured and
calibrated on February 1st, 2015, but not used until October 1st,
2015, the Calibration Start Date is August 1st, 2015.
To keep the tester in calibration, send it to an authorized service
center within 12 months of the Calibration Start Date (or the
Calibration Date if the Calibration Start Date is not shown).
If a remote tester is connected to the main tester, tap REMOTE to
see information about the remote tester.
If a link interface adapter is attached to the tester, you can tap
ADAPTER to see this information about the adapter:
Serial Number and the Hardware version of the adapter.
Autotest Count is the number of Autotests done with the
adapter. You can use this count to monitor the wear on
the adapter’s jack or plug.
Current Series is an Autotest count that you can reset. To
reset the counter, tap Reset Series.
Update the Software
New software gives you access to new features and the latest test
limits and cable types. Software updates are available on the
Fluke Networks website.
You can use a PC to install a software update, or connect an
updated main tester to a remote or to another main tester to
update those testers.
You can also use LinkWare Live to download a software update
from the cloud to your main tester, then use the main tester and
a USB cable to install the update in the remote.
To Next Page
Loading...
