Chapter 11: Maintenance
See Information About the Tester
191
BA57.EPS
Figure 74. VERSION INFORMATION Screen for the Main Tester
The versions of the databases for test limits and cable types.
These databases are part of the software version installed in the
main tester.
The Calibration Date is the date when the tester was calibrated
at a Fluke Networks factory or service center.
If the tester was used for the first time within 6 months after it
was calibrated during manufacturing, Calibration Start Date
shows. This is the date the tester was first used. This is typical for
new testers.
B
E
C
F
A
D
To Next Page
Loading...
