Chapter 8: Use Projects
Tutorial: Make a New Project
159
Total IDs: The number of IDs in the set. This section does not
show for ID sets that do not have a Last ID.
Tap IMPORT to use an ID set that you downloaded to the tester
from LinkWare PC software.
Tap REVIEW to see the CABLE ID REVIEW screen, which shows
the ID set an the total number of IDs. See “How to Make ID Sets”
on page 165.
Note
The REVIEW button is not available if you do not
enter a Last ID.
SAVE: To save the ID set, tap SAVE.
Step 5: Turn on the Auto Save Function
When Auto Save is on, the tester automatically saves results with
the next available ID. If a test fails, you can do the test again for
the same ID if necessary, or do a test for the next ID.
5-1 On the CHANGE ID screen, make sure that the Auto Save
control shows On.
5-2. Tap DONE.
To Next Page
Loading...
