Fluke DSX-600 - Audible Tone; Power Line Frequency; Display Brightness

DSX-600 CableAnalyzer
Technical Reference Handbook
26
Audible Tone
You can enable or disable the tones the tester makes during tests
and when you press keys. If you connect a remote tester to the
main tester, the remote uses the main tester’s setting.
1 On the home screen, tap the TOOLS icon.
2 In the Audible Tone panel, tap the control to show On or Off.
3 To go back to the home screen, tap or press .
Power Line Frequency
Set the power line frequency to the power frequency in the area
where you will use the tester. This setting decreases the effects of
ac noise on the circuits in the tester.
1 On the home screen, tap the TOOLS icon.
2 In the Power Line Frequency panel, tap the control to show
50 Hz or 60 Hz.
3 To go back to the home screen, tap or press .
Display Brightness
1 On the home screen, tap the TOOLS icon, then tap Display.
2 On the brightness scale, tap or slide the yellow bar to adjust
the brightness, then tap DONE.
Note
When you increase the display brightness, the
battery life decreases.
3 To go back to the home screen, tap or press .