Chapter 2: Get Started
About Projects
41
1 On the home screen, tap the PROJECT panel.
2 To save the ID set in a different project, tap CHANGE PROJECT,
then tap a project.
3 On the PROJECT screen, tap NEW ID SET.
4 On the CABLE ID SETUP screen, tap the First ID panel, then
use the keyboard to enter the first ID in your sequential set.
For this example, enter 1-01-A.
5 Tap the Last ID panel, use the keyboard to enter the last ID in
your sequential set, then tap DONE. For this example, enter
2-10-D.
6 To see the ID set, tap REVIEW.
7 On the CABLE ID REVIEW screen or the CABLE ID SETUP
screen, tap Save.
About Projects
The ProjX
™
management system lets you set up a project to
specify the settings necessary for a job, to monitor the status of
a job, and organize your test results. See Chapter 8.
The tester saves your settings and test results in the DEFAULT
project, unless you select a different project.
To Next Page
Loading...
