Fluke DSX-600 - To Select a Different Test in the Project; To Add a Test to a Project; To Save Results in a Different or New Project; How to Make ID Sets

Chapter 8: Use Projects
How to Make ID Sets
165
To Select a Different Test in the Project
1 On the home screen, tap the test setup panel.
2 On the CHANGE TEST screen tap the test you want to do. See
Figure 72 on page 161.
3 Tap USE SELECTED.
To Add a Test to a Project
1 On the home screen, tap the test setup panel or the PROJECT
panel.
2 Tap NEW TEST.
3 On the TEST SETUP screen, change the test settings as
necessary, then tap SAVE.
To Save Results in a Different or New Project
To save results in a different or new project, press home, tap the
project panel, then tap CHANGE PROJECT. Select a different
project, or tap NEW PROJECT to start a new project.
How to Make ID Sets
There are three methods you can use to make ID sets:
 Make sets of sequential IDs on the tester.
 Make sets of sequential IDs in LinkWare PC, download them
to the tester, then import them into a project on the tester.
See “Import an ID Set into a Project” on page 169. These sets
can include non-sequential IDs.
 Make an ID set in a LinkWare Live project, then sync the
project to the tester. See the help in LinkWare Live for details.