Fluke DSX-600 - Page 184

DSX-600 CableAnalyzer
Technical Reference Handbook
166
To make a set of sequential IDs, you enter the first and last ID in
the set. The tester (or LinkWare PC software) increments the
letters and numbers in the first ID from right to left to make a set
of IDs that starts with your first ID and ends with your last ID.
Special characters, letters with accents, and letters that are the
same in the first and last IDs do not increment.
For example, here is an installation with 100 cables:
 Two floors: 17 and 18
 Fifty cables on each floor: cables 1 through 50
You can make this ID set for the installation:
First ID: FLOOR 17 CABLE 01
Last ID: FLOOR 18 CABLE 50
These IDs make this set of 100 IDs:
FLOOR 17 CABLE 01
FLOOR 17 CABLE 02
FLOOR 17 CABLE 03
.
.
.
FLOOR 17 CABLE 50
FLOOR 18 CABLE 01
FLOOR 18 CABLE 02
FLOOR 18 CABLE 03
.
.
.
FLOOR 18 CABLE 50
Each project can have up to 5000 IDs. If an ID set does not have a
Last ID, the tester counts the set as one ID. An ID can have a
maximum of 60 characters.