Fluke DSX-600 - Step 4: Make ID Sets

DSX-600 CableAnalyzer
Technical Reference Handbook
156
Step 4: Make ID Sets
To see the CABLE ID SETUP screen
 On the home screen, tap the PROJECT panel, then tap NEW ID
SET on the PROJECT screen.
 Or, on the home screen, tap the Next ID panel, tap CHANGE
CABLE IDs, then tap NEW ID SET on the CHANGE CABLE IDs
screen (see Figure 69 on page 157).
To make a cable ID set
4-1 On the home screen, tap the PROJECT panel, then tap NEW
ID SET on the PROJECT screen.
4-2. For this tutorial, you will make an ID set that has 12 IDs for
twisted pair cabling:
a. On the CABLE ID SETUP screen (Figure 70 on page 158), tap
the box under First ID, use the keyboard to enter B-00.
b. Tap the box under Last ID, use the keyboard to enter D-03,
then tap DONE.
c. Tap REVIEW. The CABLE ID REVIEW screen shows the ID set
and the total number of IDs.
4-3. To save the ID set, tap SAVE on the CABLE ID REVIEW screen.