DSX-600 CableAnalyzer
Technical Reference Handbook
190
Clean the Tester
To clean the touchscreen, turn off the tester, then use a soft, lint-
free cloth that is moist with water or water and a mild detergent.
To clean the case, use a soft cloth that is moist with water or
water and a mild detergent.
WWarningX
Do not put the tester or the battery pack in water.
WCaution
To prevent damage to the touchscreen or the case,
do not use solvents or abrasive materials.
When you clean the touchscreen or the case, do not
let liquid get under the plastic around the
touchscreen.
See Information About the Tester
To see information about your tester and attached adapters
On the home screen, tap the TOOLS icon, then tap Version
Information. See Figure 74.
To see information about a remote tester
Use a patch cord to connect the main and remote testers together
(see Figure 4 on page 17), then tap REMOTE on the Version
Information screen.
Refer to Figure 74:
If the tester is connected to a wired network through the
Ethernet jack on the side of the tester, the IP address of the
tester shows.
The serial number and the software and hardware versions of
the device.
To Next Page
Loading...
