Fluke DSX-600 - To Use an ID You Used before; To Use an ID that Is Not in an ID Set that Has a First and Last ID

Chapter 8: Use Projects
How to Change Settings as You Use a Project
163
2 On the CHANGE ID screen, tap an ID in the list under IDs
Untested, then tap DONE.
3 Do the test. After you save the results, the tester uses the next
ID in the set for the next results.
If Auto Save is off:
1 Do the test, then tap SAVE if the test passed or FIX LATER if
the test failed.
2 Enter the ID on the SAVE RESULT screen, then tap SAVE. After
you save the results, the tester uses the next ID in the set for
the next results.
To use an ID you used before
 If the test failed before, turn on Auto Save, select the saved
result on the RESULTS screen, then tap TEST AGAIN or press
. See “How to Make ID Sets” on page 165.
 If the test passed before, do the test again, then enter the ID
on the SAVE RESULT screen.
To use an ID that is not in an ID set that has a first and last ID
If Auto Save is on or off:
1 On the home screen, tap the Next ID panel.
2 On the CHANGE ID screen, tap the panel that shows the Next
ID.
3 Use the keyboard to enter an ID, then tap DONE on the
keyboard.
4 The tester asks you if you want to create a new ID set (see
“About Next ID Sets” on page 168). Tap YES in the dialog box,
then tap DONE.
5 Do a test. The tester saves the results with the ID you entered.
It saves subsequent results with the IDs from the new set.
To use IDs from the set you used before, go the CHANGE ID
screen, tap CHANGE CABLE IDs, tap the ID set, then tap USE
SELECTED.