Fluke DSX-600 - Use LinkWare Live Through a Wi-Fi Ethernet Network

Chapter 9: Sync Projects with LinkWare
™
Live
Use LinkWare Live Through a Wi-Fi Ethernet Network
175
On the home screen, tap SYNC.When the tester connects to the
network, the wired network connection icon shows at the top of
the screen:
3 On the LWL SIGN IN screen, if necessary, enter the ID and
password for your LinkWare Live account, then tap SIGN IN.If
you use other people’s LinkWare Live accounts, the
ORGANIZATION screen shows. Tap the organization you want
to use.
4 On the SYNC PROJECTS screen (Figure 73 on page 177), select
the projects you want to sync, then tap SYNC.
Use LinkWare Live Through a Wi-Fi Ethernet
Network
To connect the tester to a Wi-Fi network, you must have an
optional USB Wi-Fi adapter. Fluke Networks recommends these
adapters:
 TP-LINK TL-WN725N
 NETGEAR WNA1000M
Other adapters may be suitable. For the latest list of qualified
adapters, see this topic in the Fluke Networks Knowledge Base:
www.bit.ly/1ACJeFO
The tester can use wireless network channels 1 through 11.
1 Connect the Wi-Fi adapter to the tester’s type A USB port.
2 On the home screen, make sure the Operator name is correct.
The tester uses the email address associated with the operator
name as the ID when you sign in to LinkWare Live.
If no address is associated with the name, or if you enter a
different address on the LWL SIGN IN screen, the tester
associates the name with the address you enter.
-continued-