DSX-600 CableAnalyzer
Technical Reference Handbook
158
BA56.EPS
Figure 70. CABLE ID SETUP Screen
(after you enter the first and last IDs)
First ID and Last ID: The first and last IDs in a set of sequential
IDs. See “How to Make ID Sets” on page 165.
If you do not enter a Last ID when you make an ID set, the tester
will increment the First ID to make subsequent IDs. When you
use an ID set that does not have a Last ID, the set under IDs
Untested on the CHANGE ID screen shows only the next ID.
Note
The tester does not increment symbols or
accented characters.
To Next Page
Loading...
