Fluke DSX-600 - Page 24

DSX-600 CableAnalyzer
Technical Reference Handbook
6
if the rechargeable battery becomes hot (>50 °C,
>122 °F) during the charge period.The battery door
must be closed and locked before you operate the
Product.
 The battery door must be closed and locked before
you operate the Product.
 Repair the Product before use if the battery leaks.
 Recharge the batteries when the low battery
indicator shows to prevent incorrect measurements.
 Turn off the Product and disconnect all test leads,
patch cords, and cables before you replace the
battery.
 Do not disassemble or crush battery cells and
battery packs.
 Do not put battery cells and battery packs near heat
or fire. Do not put in direct sunlight.
 Have an approved technician repair the Product.
 Use only AC adapters approved by Fluke Networks
for use with the Product to supply power to the
Product and charge the battery.
WCaution
To prevent damage to the tester or cables under
test, to prevent data loss, and to make sure your
test results are as accurate as possible:
 Do not connect the tester to an active network.
Doing so causes unreliable test results, can disrupt
network operations, and can cause damage to the
tester.
 Connect only RJ45 plugs to the adapters. Other
types of plugs, such as RJ11 (telephone) plugs, can
cause permanent damage to the jacks.