EtherScope
TM
Series II
Getting Started Guide
14
Recalibrating the Screen
The touch-sensitive screen is calibrated at the factory.
Though unlikely, the instrument may not respond properly
when you tap the stylus on the screen. If this happens, you
may need to recalibrate the screen. Recalibration aligns the
instrument’s internal circuitry with the screen so that it can
correctly detect taps with the stylus.
To recalibrate your screen:
1
Using the stylus, tap the desktop icon
, which is
located in the lower-left corner of the screen. From
the menu, select Settings.
2
On the Settings screen, tap the Recalibrate icon .
Follow the prompts to complete the recalibration.
Enabling Software Options
If you purchased a software option for your EtherScope
Network Assistant, you received a proof-of-purchase code
along with a software option activation instruction card.
Follow the instructions on the card to obtain a key code from
the Fluke Networks website and use that key code to
activate your option.
Note
If you need help obtaining your key code, contact
Fluke Networks for assistance. See “Contacting Fluke
Networks ” on page 8 for information on how to
contact us.
To enable one or more software options, have your
instrument’s key code handy, and then do the following:
1
Tap the EtherScope Master Menu icon
(
located in
the upper-left corner of each screen).
To Next Page
Loading...
