Fluke II Series - Network Connections; External Interfaces; External Power Connection

EtherScope
TM
Series II
Getting Started Guide
20
Network Connections
The instrument’s network connections are located on the top
side panel:
• LAN copper: an RJ-45 port that provides direct
connection to IEEE 802.3 10/100/1000BASE-TX
networks.
• LAN fiber: an SFP port that provides direct connection
to networks through the optional 1000BASE-SX,
1000BASE-LX, or 1000BASE-ZX fiber connection.
• SLOT 1: a PCMCIA/CardBus
®
interface that supports an
802.11 wireless network. Accepts Fluke Networks
EtherScope Wireless LAN Adapter IEEE 802.11 a/b/g.
External Interfaces
The following external interfaces are located on the
instrument’s right side panel:
• Serial DB-9: provides a network device connection via a
serial cable.
• Headphone: enables quiet operation of the instrument
(for future applications).
• Microphone: (for future applications).
• USB port: connection for an accessory, such as a
keyboard or mouse
SLOT 2 is located on the top side panel. This interface accepts
a CompactFlash
®
(type 1 and 2) memory card. This memory
card enables you to store test data and temporarily hold files
that are transferred from a PC during a software update
External Power Connection
The DC power jack is located on the instrument’s right side
panel. Plug the supplied AC adapter into this jack to provide
external power to the EtherScope Network Assistant and to
charge the battery.