Physical Features
19
Operating the Instrument on External Power
When the instrument is connected to AC power, you can use
the power supply as a continuous power source. In this way,
you can test for long periods of time without depleting the
battery.
To operate the instrument using AC power, refer to Figure 2
and do the following:
1
Connect the power cord to the external AC adapter
charger.
2
Connect the AC adapter charger to the power jack on
the instrument’s side panel.
3
Turn on the instrument.
You can also power the instrument and charge it at the same
time with the (optional) auto lighter charger. Plug one end
of the auto lighter charger into the instrument and the
other end into a vehicle power outlet.
Physical Features
The EtherScope
Network Assistant is designed to be used as a
dispatched or desktop network test device. The instrument is
shipped with a removable yellow holster that provides more
protection for dispatched tasks.
The instrument is also packaged with a stand for use on a
desktop. To access the stand, remove the yellow holster.
Then, pull the stand out from the bottom of the instrument
(see Figure 2).
A stylus for navigating the user interface is stored in the right
side panel near the green On/Off button.
Figure 2 illustrates the EtherScope Network Assistant’s
physical features.
To Next Page
Loading...
