EtherScope
TM
Series II
Getting Started Guide
36
Configuring the Instrument for a Wired LAN
Although EtherScope Network Assistant is designed to
provide as much automated configuration as possible, every
network is different. For the instrument to provide you with
the best network analysis possible, you may need to change
some of the default configuration settings.
To access the instrument’s configuration screens, do the
following:
1
Tap the EtherScope Network Assistant icon ,
which is
located in the upper-left corner of the title bar.
2
From the drop-down list, tap Instrument Settings.
The Instrument Settings —TCP/IP screen (Instrument
Settings—TCP/IP Screen) is displayed (Figure 7).
On this screen, you configure the instrument’s TCP/IP
settings:
feb86s.tif
Figure 7. Instrument Settings—TCP/IP Screen
Tap a hyperlink in the preview pane to display other
configuration screens, which are described in the sections
that follow.
To Next Page
Loading...
