Fluke II Series - User Interface Events that will Terminate a Remote Session

Accessing the Instrument Remotely (LAN only)
55
4 To access real-time reports:
a Click .
The EtherScope Real-Time Reports screen is
displayed.
b Locate the report that you want to view, and then
click a link to display it.
5 To access saved reports:
a Click .
The EtherScope Real-Time Reports screen is
displayed.
b Click View Saved Reports.
c Select the saved report that you want to view, and
then follow the link to view it.
User Interface Events That Will Terminate a
Remote Session
The active TCP/IP session between the remote user interface
software and the instrument can be severed under the
following conditions:
• If IP parameters are manually changed on the
instrument and Apply is selected on the Instrument
Settings—TCP/IP screen
• If the Start Test button is selected on the Cable
Verification Details screen.
• If the Start Test button is selected on the Signal
Verification Details screen.
• If the instrument’s MAC address is changed in the
Instrument Settings—Ethernet screen.
• If the Ethernet link goes down.