Versiv Series Cabling Certification Product Family
Technical Reference Handbook
364
4 To make a new measurement, tap the yellow circle, tap
UNMARK (
), then do steps 1, 2, and 3 again.
GPU18.EPS
Figure 149. How to Use the Measurement Cursor on the ODTR Trace
Refer to Figure 149:
To specify the start of a measurement, tap the yellow circle (),
then tap MARK.
To see the MARK and UNMARK buttons, tap the yellow circle.
To move the cursor in small increments, tap or press and hold
or . If these buttons do not show, tap the yellow circle
on the cursor.
The measurement in the square is the distance from the start
of the fiber to the yellow cursor.
To Next Page
Loading...
