Chapter 17: Use Projects
Tutorial: Make a New Project
529
Auto Save: When a test is completed, the tester automatically
saves the results with the next ID from the ID set. If the test
failed, you can do the test again for the same ID, or go to the
next cable. If you go to the next cable, the tester shows the failed
test at the top of the list of results for the ID set.
Next ID: The Next ID is the ID that the tester gives to the next
results you save.
To edit the ID, tap the ID, use the keyboard to edit the ID,
then tap DONE. If the ID is not in the current set, the tester
will make a new ID set that uses the ID as the first ID.
To select a different ID from the set of untested IDs, tap
the ID in the set (
).
End 1:, End 2: When you select a fiber ID set for tests with an
OptiFiber Pro OTDR module or for tests on single fibers with a
CertiFiber Pro OLTS module, this panel shows the name for the
ends of the fiber. The tester uses the names when you save
results for each end of the fiber. To edit the name for the end
shown, tap the panel. To change the end that is shown, tap the
End 1/End 2 control (item
).
IDs Untested: The number of IDs that do not have results. For
fiber IDs, the list shows the IDs that do not have results for the
test shown (Auto OTDR in this example) and the End selected
(item
).
This list shows IDs that do not have results. For fiber IDs, the list
shows the IDs that do not have results for the test shown and the
End selected. On the home screen, the tester shows 100%
Tested when this list shows no IDs for all test types specified in
the project.
When you use a Next ID set, which does not have a Last ID, the
tester does not know how many IDs are necessary for the ID set.
For Next ID sets, this list shows only the next ID.
Tap CHANGE CABLE IDs to select a different ID set to use or to
edit an ID set.
To Next Page
Loading...
