FOR-A FA -10DCCRU - 2 Main Unit Compatibility; FA-505 Compatibility; FA-1010 Compatibility; FA-9520 Compatibility

10
2. Main Unit Compatibility
FA-10DCCRU units do not support all FA-505, FA-1010, FA-9520 or FA-9500 versions.
Refer to the tables below for compatibility details. Main units with earlier software versions are
unable to be (or to be fully) controlled by FA-10DCCRU units.
Upgrade your main unit if it is fully or partially incompatible with the FA-10DCCRU.
2-1. FA-505 Compatibility
The table below shows information on FA-505 / FA-10DCCRU compatibility.
FA-505
Soft Version 1.00 - 1.10
Able to be controlled, with the following functions unavailable:
RGB Clip (HDR)
Color Space settings
Gamma Range
FA-505
Soft Version 2.00 or higher
Able to be fully controlled.
2-2. FA-1010 Compatibility
The table below shows information on FA-1010 / FA-10DCCRU compatibility.
FA-1010
Software Ver. 1.00 - 2.01
Unable to connect with FA-10DCCRU.
FA-1010
Software Ver. 2.22
Able to be controlled, with the following functions unavailable:
BY-PASS/OPERATE
Y Level
SPLIT
RGB Clip (HDR)
Color Space settings
Gamma Range
FA-1010
Software Ver. 3.00 or higher
Able to be controlled, with the following functions unavailable:
RGB Clip (HDR)
Color Space settings
Gamma Range
Refer to the FA-1010 Operation Manual for details on software version verification.
2-3. FA-9520 Compatibility
The table below shows information on FA-9520 / FA-10DCCRU compatibility.
FA-9520 mode
Software Ver. 1.00 - 2.01
FA-9500 mode
Software Ver. 7.00 - 8.01
Unable to connect with FA-10DCCRU.
FA-9520 mode
Software Ver. 2.02 or higher
FA-9500 mode
Software Ver. 8.02 or higher
Able to be controlled, with the following functions unavailable:
BY-PASS/OPERATE
Y Level
SPLIT
RGB Clip (HDR)
Color Space settings
Gamma Range
Refer to the FA-9520 Operation Manual for details on software version verification.