FOR-A FA -10DCCRU - Messages During Bypass Setting; Messages During FS Selection

50
Displayed message
(Full / Simple)
When information/message is displayed:
Refer to
Over Limit
(IP **. **. **. **)
When FA-10DCCRU is attempting to connect to a main
unit, the main unit has connected with 5 remote control
units (maximum) and this connection fails.
To connect to the main unit, the main unit must
disconnect one of the connected remote control units.
This message may also be displayed when a
disconnection is being improperly performed. Note that
it will take 1 minute at most to complete the
disconnection process.
6-1
Connected: IP **.**.**.**(No
Name)
When FA-10DCCRU is connected to a main unit in
Direct Connection mode and no Unit Name is set for the
main unit, its IP address is displayed.
The message is cleared when there is no operation
within 1 minute.
Connected: FA-1010
When FA-10DCCRU is connected to a main unit in
Direct Connection mode, the message is displayed with
its Unit Name (FA-1010) for about 7 seconds.
6-1
MU is Local Mode
When the FA-10DCCRU is connected to a main unit,
but the main unit operates in local mode, this message
will appear and the main unit cannot be controlled from
the FA-10DCCRU.
To control the main unit, change the operation mode to
Remote in the main unit.
-
9-2. Messages during Bypass Setting
Displayed message
(Full / Simple)
When information/message is displayed:
Refer to
By-pass
Displayed when the connected FA-505/FA-1010 is set to
Bypass.
6-2
Operate
(*1)
Displayed when the connected FA-505/FA-1010 is set to
Operate.
6-2
By-pass No Support
(*1)
Displayed when trying to set to Bypass for the main unit that
has no bypass function.
2
6-2
(*1) The display is automatically turned off when there is no operation within 1 minute.
9-3. Messages during FS Selection
Displayed message
(Full)
Displayed message
(Simple)
When information/message is
displayed:
Refer to
FS*
(Same as in Full mode)
FS number of connected FA-9520
(9520 mode).
6-3
FS*: FS1 Name
FS*
FS number and FS Name (FS1
Name) of connected FA-505/
FA-1010.
6-3
FS*(No Name)
FS*
FS number (without FS Name) of
connected FA-1010.
See the FA-505/FA-1010
Operation Manual for details on
how to assign names to FSs.
6-3
FS Select No Support
(Same as in Full mode)
Displayed when attempting to
select an FS for an FA-9520
(FA-9500 mode) or FA-9500.
The display is automatically turned
off when there is no operation
within 1 minute.
2
6-3