31
6-6. UNITY Settings and Indicators
Three indicators on each level control button indicate level status as shown below
A center indicator that is turned on indicates the level is set to UNITY.
A left indicator that is turned on indicates the level is set to less than UNITY level.
A right indicator that is turned on indicates the level is set to more than UNITY level.
Pressing a UNITY button resets the associated value to default. Pressing the button again
returns the default value to the previous value.
An error alarm will sound when a higher or lower limit is exceeded.
6-7. UNITY Button and Unity Mode
UNITY buttons have two operation modes: Unlinked Unity and Linked Unity.
Unlinked Unity mode
UNITY is applied only to the selected FS.
Linked Unity mode
UNITY is applied to all linked FS channels (FS Link On).
* See section 8. “SYSTEM Settings” for more details on setting UNITY mode.
* See section 11. “FS Link” for more details on FS Linking.
6-8. Process Control (Proc Amp)
In this section, use the following parameters to perform Proc Amp adjustments.
Adjusts the luminance level.
* Y LEVEL can be adjusted when the FA-1010 software version
is 3.00 or higher.
Y LEVEL is unable to be adjusted for FA-9520 or FA-9500.
Adjusts the CHROMA LEVEL. (Adjusts the sepia level in Sepia
Mode.)
Adjusts the SETUP/BLACK level.
Adjusts the HUE. (Adjusts the SEPIA color in Sepia Mode.)
Proc Amp is disabled while in Bypass, MU Selection, Clip Setting or System Setting
mode.
Proc Amp settings do not appear when FS SEL is lit.
Note that changes are applied to all linked FS channels (FS Link On) in FA-505,
FA-1010 or FA-9520 (FA-9520 mode). See section 11. “FS Link” for more details.
To Next Page
Loading...