FOR-A FA -10DCCRU - Page 13

13
No.
Name
Description
(9)
GAMMA LEVEL
Allows you to adjust the gamma level. In Sepia mode, only Y signal can
be adjusted using the G control button.
The level adjustment applies to the selected FS if controlling an
FA-505, FA-1010 or FA-9520 in FA-9520 mode.
(10)
FREEZE
Allows you to toggle Freeze On or Off. The button turns on while the
video is frozen. See section 6-4. “Freeze Setting.”
The setting applies to the selected FS if controlling an FA-505,
FA-1010 or FA-9520 in FA-9520 mode.
CLIP
Allows you to toggle the mode between Color Correction and Clip.
Holding down the buttons simultaneously changes the mode to Clip.
See section 6-10. ” Clipping Signal Levels.”
The setting applies to the selected FS if controlling an FA-505,
FA-1010 or FA-9520 in FA-9520 mode.
SPLIT
(*1)
Allows you to change the video display mode in the following order:
OFF > MODE1 > MODE2 > MODE3.
The setting applies to the selected FS (by FS SEL) in an FA-1010.
(11)
UNITY
(*2)
Pressing the UNITY button resets the value to default. Pressing the
button again returns the default value to the previous value.
(12)
WHITE/
CENTER/
BLACK
Selects a gamma curve from WHITE, CENTER or BLACK.
The setting applies to the selected FS if controlling an FA-505,
FA-1010 or FA-9520 in FA-9520 mode.
(13)
BAL/DIF/SEPIA
Selects a correction type for Color Correction mode from the following:
BAL (Balanced, mainly used for RGB signals)
DIF (Differential, mainly used for YPbPr signals)
SEPIA (Sepia color)
The setting applies to the selected FS if controlling an FA-505,
FA-1010 or FA-9520 in FA-9520 mode.
(*1) Split control is available if the FA-1010 software version is 3.00 or higher.
Split control is not available for FA-9520 or FA9500.
(*2) Two operation modes, Linked Unity and Unlinked Unity, are available for setting WHITE
LEVEL, BLACK LEVEL and GAMMA LEVEL using the R, G and B UNITY buttons. See
section 8. “SYSTEM Settings” and Section 6-7. “UNITY Button and Unity Mode” for more
details.