FORST ST6P - Service Schedule; Table 8 - Service Schedule

Redwood Global Ltd - ST6P
Operator and Maintenance Manual
Chapter 5: Maintenance
5.21 SERVICE SCHEDULE
NOTICE
Remember to carry out the Redwood Global Ltd standard inspection at every
service.
Table 8 - Service schedule
Hours of
operation
Tasks Requirements
and part
numbers
20 Remove and replace hydraulic oil filter element. 12-24-054
Top up hydraulic oil, if required. VG ISO 46
Check flywheel bearing grub screws.
If required, tighten to 16Nm.

100
Replace spark plugs.
• Required gap: 0.030in (0.76mm)
• Required torque: 20Nm
24-99-005
Drain and replace engine oil. Synthetic 5W-
30
Remove and replace engine oil filter. 24-99-003
Replace outer air filter. 24-99-001
Replace fuel filter. 24-99-004
Check valve clearances and adjust, if required:
• Intake valve clearance: 0.004-0.006in (0.10-0.15mm)
• Exhaust valve clearance: 0.007-0.009in (0.18-0.23mm)
Competent
person
Check and sharpen feed rollers, if required.
Clean oil cooler fins. 
Strip, clean and adjust brakes, as per manufacturer's specification.
Competent
person
Check and remove any debris from the fuel tank. 
200 Perform all 100 hour tasks. 
300 Perform all 100 hour tasks. 
Replace inner air filter. 24-99-002
Replace bottom feed roller inner bush. 12-01-052
Remove engine front cover and clean cooling system.
Competent
person
400 Perform all 100 hour tasks. 
500
Perform all 100 hour tasks. 
Remove and replace hydraulic oil filter element. 12-24-054
Top up hydraulic oil, if required. VG ISO 46
600 Perform all 300 hour tasks. 
700 Perform all 100 hour tasks. 
800 Perform all 100 hour tasks. 
12-00-001 v4.0 106