FORST ST6P - Routine Maintenance

Redwood Global Ltd - ST6P
Operator and Maintenance Manual
Chapter 5: Maintenance
5.1 ROUTINE MAINTENANCE
WARNING
Make sure the key is removed from the ignition before commencing any service
or maintenance on the machine.
NOTICE
When the machine is new, the hydraulic oil level may drop during initial use.
Regularly check and top-up until the level settles.If a top up is required,
thoroughly clean around filler cap before removing to help prevent debris falling
into oil tank, top up as required and replace filler cap.
WARNING
Exercise extreme care to avoid injury when removing and replacing blades and
anvils. The flywheel can turn creating crush and cutting points in and around the
chipping chamber.
WARNING
Beware of hydraulic oil leaks, they can cause serious injury while the engine is
running and the system is under pressure.A leak can easily inject high pressure
oil deep into flesh and blood stream requiring immediate medical attention. Do
not check for leaks while the engine is running.Hoses to the feed roller hydraulic
motors are the most likely to become damaged as they are constantly moving
during use. If hoses are replaced, all seals must be replaced at the same time.
WARNING
Damaged hydraulic hoses can cause fatal accidents. Inspect the hoses regularly.
Do not use the machine if a hose or hose fitting is damaged.
WARNING
Fluid Under Pressure.
Fine jets of fluid at high pressure can penetrate the skin. Keep face and hands
well clear of fluid under pressure and wear protective glasses and gloves. turn
off the engine before checking for leaks. If fluid penetrates your skin, get
medical help immediately.
12-00-001 v4.0 72