Redwood Global Ltd - ST6P
Operator and Maintenance Manual
Preface
PURPOSE OF THESE INSTRUCTIONS
Thank you for purchasing/hiring this Redwood Global Ltd, Först wood chipping
machine.
The purpose of this document is to make you familiar with the operation and
maintenance of the machine, so that you can safely operate it as an end-user. This
documentation should therefore be regarded as an integral part of the machine.
By observing the contents of this manual, we hope the machine gives safe and
productive service. This user manual is intended for the owner/operator to safely and
effectively operate this machine and carry out routine maintenance between services.
This is not a comprehensive service manual. Refer to the Service Schedule for routine
maintenance and when to take the machine to a service specialist.
This machine has been through a pre-delivery inspection before leaving the factory and
is ready to use.
CAUTION
Before use and as a minimum, the safety and machine operation sections
covered in Chapters 3 and 4 must be read and understood.Failure to do so
could result in serious injury or loss of life to the operator and others nearby.
Also, damage to property and this machine may occur. Please observe and
obey all warning signs (decals) located on the machine. Their meaning is
covered in Refer to "Decals" on page 42.
Redwood Global Ltd endeavour to continuously develop and improve its products. They
reserve the right to make changes at any time, without notice or incurring any obligation.
Continuous improvement will affect machine design and production so there may be
minor discrepancies between the actual product and this manual.
12-00-001 v4.0 12
To Next Page
Loading...
