Display of the warning with the system data
Display of the warning with Job optimization
Additional information on reactions at the interface to a warning:
- During welding, the limit signal (WORD 1 / Byte 2 / Bit 19) reacts directly to exceed-
ing or falling below the limits
- If no overshoot or undershoot of the limits is detected, the Limitsignal Low
remains
- If an overshoot or undershoot of the limits is detected, the Limitsignal changes
to High
- As soon as the welding parameters are within the defined limits again, the Limit-
signal changes back to Low after 1 second
- No warning number is output at the interface (WORD 9 / Byte 18 - 19 / Bit 144 - 159)
75
EN-US
To Next Page
Loading...
