6-1
MHT260a (Engl.)
6. PARAMETER SETTING
About parameter
There are two types of parameters; basic parameter and system parameter.
Parameter Basic parameter (approx. 99 settings)
System parameter (approx. 99 settings)
Set the parameters according to the motor usage and mechanical equipment system.
■ Basic parameter
The basic parameters are rather frequently adjusted, such as acceleration/deceleration time and manual feed speed.
Changed setting of most basic parameters immediately affects the amplifier and the motor actions.
■ System parameter
The system parameters are not frequently changed once they are set, such as function allocation to control input/output terminal and
offset adjustment.
Changed setting of most system parameters is valid only after turning off and on power.
Make sure that the keypad panel indication (7-segment) goes off when power is turned off.
Because the contents of parameter setting are stored in rewritable ROM (EEPROM), they cannot be lost even if power is turned off.
Specific basic parameters can be stored in RAM and rewritable infinitely.
To Next Page
Loading...
