Fuji Electric Faldic-a RYS-R Series - Speed Command Offset; System Parameter 63, 64.!Basic Type; Speed Command Gain

6-36
MHT260a (Engl.)
(6) System parameter 63, 64.!Basic type"
Para. Name Setting range Initial value Change
63 Speed command gain #0.10 to #1.50 times (in 0.01 step) 1.00 Always
64 Speed command offset –2000 to 2000 (in 1 step) (Individual) Always
The gain or offset of speed command [NREF] terminal can be adjusted.
$ Speed command gain
These gains can be set from #0.10 to #1.50 times in 0.01 step.
Specifying the negative sign can invert the rotational direction.
$ Speed command offset
This can be set from -2000 to 2000 in 1 step. The setting value has no unit. The initial value has been set at factory shipment individually.
Automatic offset adjustment is enable in the trial operation mode by the keypad panel ([
]). The value after adjustment will be saved
in the system para. 64
(7) System parameter 67 to 73!Basic type, SX bus, monitor 2 of T-link"
Para. Name Setting range Initial
value
Change
67 Monitor 1 signal assignment 1: Speed command 2: Speed feedback
3: Torque command 4: Position deviation
2Always
68 Monitor 2 signal assignment 1: Speed command 2: Speed feedback
3: Torque command 4: Position deviation
3Always
69 Monitor 1 scale #2.0 to #10 [V] (in 0.1 step) 7.0 Always
70 Monitor 1 offset –50 to 50 (in 1 step) 0 Always
71 Monitor 2 scale #2.0 to #10 [V] (in 0.1 step) 6.0 Always
72 Monitor 2 offset –50 to 50 (in 1 step) 0 Always
73 Monitor 1, 2 output form 0: Monitor 1 (two-way deflection) / Monitor 2 (two-way deflection)
1: Monitor 1 (one-way deflection) / Monitor 2 (two-way deflection)
2: Monitor 1 (two-way deflection) / Monitor 2 (one-way deflection)
3: Monitor 1 (one-way deflection) / Monitor 2 (one-way deflection)
0 Power
Speed command voltage
* : System para. 63 setting
%&'(
!
)'''r/min
*)'''r/min
*&'(
+,&-).
"""""""
/+,&-'.
""
//////
/////
Speed
+,'-&.