11-10
MHT260a (Engl.)
11.2 Control block diagram
The control block diagram for RYS-R type amplifier is shown on the next page.
(1) Override
Validated by allocating the control assign terminals [CONTn] to signals.
Setting value Signal name
43 Override valid
44 Override 1
45 Override 2
46 Override 4
47 Override 8
(2) Manual feed
The speed of manual forward or reverse rotation can be selected by multistep speed selection [X1], [X2] and [X3].
X3 X2 X1 Speed
OFF OFF OFF Speed set by speed command [NREF] terminal
OFF OFF ON Speed set by basic para. 1
OFF ON OFF Speed set by basic para. 2
OFF ON ON Speed set by basic para. 3
ON OFF OFF Speed set by basic para. 4
ON OFF ON Speed set by basic para. 5
ON ON OFF Speed set by basic para. 6
ON ON ON Speed set by basic para. 7
See 5.3.1 Forward command [FWD]/Reverse command [REV], and 5.7.3 Override.
To Next Page
Loading...
