7-20
MHT260a (Engl.)
(3) Position preset (
)
The current position of motor can be preset. The following alarm detection can be reset.
・ABS data loss
Current position is the followings :
(a) [D14] to [D0] input value for RYS□□□S3-RPS type
(b) Station No. of 8, 9 word position for RYS□□□-RSS type
(c) Station No. of +6, +7 word position for RYS□□□S3-RTS type
Position preset cannot be made while the motor is rotating and while on status of the clamping end signal.
(4) Alarm reset (
)
Resets the alarm detected by the amplifier.
(5) History initialization (
)
Deletes the history of alarms detected held by the amplifier.
This history can be monitored by a sequence mode of [
].
The alarm history is held even after turning off power.
(6) Parameter initialization (
)
Initializes the basic para. and system para.
* After initializing, be sure to turn off and on power.
ENT (1 [s] or more)
ESC
ＥＮＴ
ＥＳＣ
ＥＮＴ
ENT (1 [s] or more)
ESC
ENT
ESC
(Initializing end)
(Initializing end)
ENT
ENT (1 [s] or more)
ESC
ESC
ESC
ENT (1 [s] or more)
ESC
Preset end
ESC
ENT
To Next Page
Loading...
