Fuji Electric Faldic-a RYS-R Series - Output Signal; Load Inertia Ratio

MHT260a (Engl.)
7-13
(13) Output signal
Displays whether the control output signals from the amplifier are turned on or off. If signals are turned on, corresponding LEDs are lit.
Note : Depending on the amplifier type, the number of control output signals changes.
(14) Load inertia ratio
Displays the load inertia ratio recognized by the amplifier regardless of the tuning method (basic para. 31).
(Load inertia ratio)＝
Displays the magnification (in 0.1 step) of the moment of inertia of the motor.
Pressing the MODE key holding down the
SHIFT key interchanges the H side and L side.
ENT (1 [s] or more)
ESC
[OUT24]・・・・・・・・・・・・・・・[OUT18] [OUT17]
[OUT32]・・・・・・・・・・・・・・・・・・[OUT26] [OUT25]
[OUT8]・・・・・・・・・・・[OUT2] [OUT1]
[OUT16］ ・・・・・・・・・[OUT10] [OUT9]
ENT (1 [s] or more )
EST
(Moment of inertia recognized by amplifier)
(Moment of inertia of motor)