11-13
P PA：Parameter editing mode
Para.：Parameter
PC：Personal computer
PC-board：Printed-circuit board
P-control：Proportional band control
PD：Current (present) position output
PE：Main circuit trouble, Power error
PG：Encoder detector, Pulse encoder, Pulse generator
PLC：Programmable logic controller
PMON：Position monitor
PO：Positioning data editing mode
POWER：Power on
PRE：Display key of data before (previous) one screen
(or No.) display
PSET：Positioning end, Indexing (dividing) end
PWRT：Parameter (re)write
R RDY：Ready
RES：Reset mode
REV：Reverse direction
Reverse direction：(*)
rH：Braking (DB) resistor overheat, Resistor heat
rH2：Resistor overheat 2, Resistor heat 2
RST：Alarm reset
RUN：Run command
S S-curve：Non-linear
SE：System error
SEQ：Sequence mode
SIGN：Rotational direction
SSC：Solid state contactor
START：Auto start
STOP：Forced stop key
STORE：Write-in of numerical setting key
SW：Setting switch
T tE：Bus communication error, Terminal error
TLMT：Torque limit
U UV：Undervoltage
V VEL：Rotation speed selection
W WPSET：Indexing (dividing) end
WRT：Position preset, Position data (re)write
WRTE：(Re)write end
X X1：Multistep speed selection X1
0 0V：Common monitor, check pin
Note (*)
Direction of motor shaft rotation (when viewed from a point facing the drive-end of motor) is designed according to Japanese standard：
・Forward direction：Counter-clockwise (CCW) rotation
・Reverse direction：Clockwise (CW) rotation
To Next Page
Loading...
