275
11.5 Emulation
Color Mode 5 - - [0] (Default: ESC/P): Color
- 216 - [0] (Default): Automatically Select
[1]: Color
[2]: Monochrome
- - 105 [0] (Default): Color
[1]: Grayscale
[2]: Black pen
Auto Layout - - 106 [0] (Default): ON
[1]: OFF
Palette Setup - - 107 [0] (Default): Command
[1]: Panel
Output quantity 8 - 108 [1] to [250] (Default: 1): 1 to 250 copies
If the machine receives a job from a client PC that specifies
the print quantity, that quantity will be applied for printing.
After the job is printed, the quantity set on the control panel
also becomes this value. However, the number of copies
specified from the lpd port does not change.
- 212 - [1] to [999] (Default: 1): 1 to 999 copies
Output destination 9 204 109 [0] (Default): Center tray (Lower)
[1]: Side tray (optional)
[2]: Center tray (Upper) (optional)
[80]: Finisher tray (optional)
[81]: Finisher output tray (optional)
2 sided 12 - 110 [0] (Default): None
[1]: Long Edge Flip
[2]: Short Edge Flip
- 206 - [0] (Default): Off
[1]: ON
Binding method for two-
sided printing
- 217 - [0] (Default): Long Edge Flip
[1]: Short Edge Flip
Paper Orientation 19 205 - [0] (Default): Portrait
[1]: Landscape
Page position
Cannot be configured
when [Document
Size] is [Continuous
paper].
20 - - [0] (Default): No cut sheet feeder (left)
[1] (initial value): Cut sheet feeder (center)
If FF (form feed command) is received when there is no cut
sheet feeder, line feeding is performed by only the value
configured by VFU. When there is a cut sheet feeder, a form
feed is performed.
Setting Item No. Setting value
ESC PCL HP
To Next Page
Loading...
