168 Using the Operator Panel Menus and Keypad
• Reset Wireless
Purpose:
To reset the wireless connection settings. After executing this function, all information about the access point is
cleared.
Values:
NOTE:
• This item is displayed only when Wi-Fi is set to On.
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
NOTE:
• To set an IP address for IPv6 in Dual Stack mode, use the CentreWare Internet Services. For more information, refer to the
online Help on the CentreWare Internet Services.
• This item is displayed only when Wi-Fi is set to On.
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and then on.
Values:
No* Does not reset the wireless connection settings.
Yes Resets the wireless connection settings.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Uses IPv4 to set the IP address.
IPv4
Wireless
Get IP Address DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator panel.
IP Address Manually sets the IP address allocated to the printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
LPD Disable Disables the Line Printer Daemon (LPD) port.
Enable* Enables the LPD port.
Port 9100 Disable Disables the Port 9100 port.
Enable* Enables the Port 9100 port.
IPP
*1
Disable Disables the IPP port.
Enable* Enables the IPP port.
WSD
(Web Services on
Devices)
Disable Disables the Web Services on Devices (WSD) port.
Enable* Enables the Web Services on Devices (WSD) port.
SNMP Disable Disables the Simple Network Management Protocol (SNMP) UDP port.
Enable* Enables the SNMP UDP port.
StatusMessenger Disable Disables the StatusMessenger feature.
Enable* Enables the StatusMessenger feature.
To Next Page
Loading...
