Printer Connection and Software Installation 51
Using Installer to Set Up Connection and Install Software
NOTE:
• The following procedure sets up printer connection and then install the drivers and software. If you have already established
printer connection, see "Using Installer to Install Software" on page 53 to install the print driver and software immediately.
Launching the FX Printer Installation Screen
1 Insert the Software Pack CD-ROM into your computer to start the FX Printer Installation screen.
NOTE:
• For Windows 8, Windows 8.1, Windows Server
®
2012, and Windows Server 2012 R2, click the message displayed on
the upper right corner of the screen, and then select Run setup.exe.
• If the CD does not automatically launch, perform the following steps.
a For Windows Server 2003, Windows Server 2008, and Windows Server 2008 R2, click Start Run.
For Windows Vista
®
and Windows 7, click Start All Programs Accessories Run.
For Windows 8 and Windows Server 2012, right-click on the Start screen and click All apps Run.
For Windows 8.1 and Windows Server 2012 R2, click
on the Start screen Run.
b Enter "D:\setup.exe" (in case your optical disk drive is D), and then click OK.
2 Click Setup Printer and Install Software.
3 If you agree to the terms of the License Agreement, choose I accept the terms of the license agreement,
and then click Next.
To Next Page
Loading...
Need help?
General
