Using the Operator Panel Menus and Keypad 165
Admin Menu
Use Admin Menu to configure a variety of printer features.
NOTE:
• A password is required to enter Admin Menu when Panel Lock Set is set to Enable. In this case, enter the password you
specified, and press the button.
Network
Use the Network menu to change the printer settings affecting jobs sent to the printer through the network.
NOTE:
• The value marked by an asterisk (*) is the factory default setting.
• Wireless Status
Purpose:
To confirm the wireless communication status. No changes can be made on the operator panel to improve the status
of the wireless connection.
Values:
*1
WPA stands for Wi-Fi Protected Access
®
.
NOTE:
• This item is displayed only when Wi-Fi is set to On.
• Wireless Setup
Purpose:
To configure the wireless network interface.
Values:
Connection Good
Acceptable
Low
No Reception
SSID Displays the name that identifies the wireless network.
Encryption Type No Security
WEP
WPA2
*1
-PSK-AES
Mixed mode PSK
Select Access Select the access point from the list. The access points are listed starting with the one in the best
communication condition.
WEP Key Entry When you select an access point using WEP as the security method, enter the
WEP key. For 64bit keys, enter 10 hexadecimal characters. For 128bit keys,
enter 26 hexadecimal characters.
PassPhrase
Entry
When you select an access point using WPA, WPA2, or Mixed as the encryption
type, enter the passphrase of 8 to 63 alphanumeric (or 64 hexadecimal)
characters.
To Next Page
Loading...
Need help?
General
