Troubleshooting 207
8 Close the rear cover.
Jam Problems
Misfeed jam
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
Multi-feed jam
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
Problem Action
Print media misfeeds occur. Remove the paper from the PSI, and then make sure that the paper is properly
inserted in the MPF.
Depending on the print media you use, take any of the following actions:
• For thick paper, use the one that is 163 gsm or less.
• For thin paper, use the one that is 60 gsm or more.
• For the envelope, make sure that it is properly loaded in the MPF or the PSI as
instructed in "Loading Envelope in the Multipurpose Feeder (MPF)" on page 89
or "Loading Envelope in the Priority Sheet Inserter (PSI)" on page 93.
If the envelope is deformed, correct it or use another envelope.
If performing manual duplex printing, make sure that the print media is not curled.
Fan the print media.
If the print media is damp, turn over the print media.
If the problem continues, use print media that is not damp.
Problem Action
Print media multiple feeds occur. Remove the paper from the PSI, and then make sure that the paper is inserted
properly in the MPF.
If the print media is damp, use print media that is not damp.
Fan the print media.
To Next Page
Loading...
Need help?
General
