176 Using the Operator Panel Menus and Keypad
See also:
• "Resetting to Factory Defaults" on page 192
Values:
• Non-Genuine Mode
Purpose:
To use toner cartridges of another manufacturer.
NOTE:
• Using non-genuine toner cartridges may make some printer features unusable, reduce print quality and decrease the
reliability of your printer. Fuji Xerox recommends only new Fuji Xerox brand toner cartridges for your printer. Fuji Xerox does
not provide warranty coverage for problems caused by using consumables not supplied by Fuji Xerox.
• Before you use toner cartridges of another manufacturer, be sure to restart the printer.
Values:
• Adjust Altitude
Purpose:
To specify the altitude of the location where the printer is installed.
The discharge phenomenon for charging the photo conductor varies with barometric pressure. Adjustments are
performed by specifying the altitude of the location where the printer is being used.
NOTE:
• An incorrect altitude adjustment setting leads to poor printing quality or incorrect indication of remaining toner.
Values:
• Machine Life
Purpose:
To specify whether to continue print operations when the printer comes to the end of its service life.
Values:
NOTE:
• When the printer no longer operates showing the error code 191-310 on the LCD panel, press the (Back) button and the
button at the same time and change the Machine Life setting to Continue Print. Then, you can keep using the
printer.
• Although you can keep using the printer after the end of its service life by changing the setting to Continue Print, the
printing quality is not guaranteed.
System Section Yes Initializes the system parameters.
No* Does not initialize the system parameters.
User Scan Section Yes Initializes the e-mail and server address entries in the Address Book.
No* Does not initialize the e-mail and server address entries in the Address Book.
Off* Does not use toner cartridges of another manufacturer.
On Uses toner cartridges of another manufacturer.
0m* Specifies the altitude of the location where the printer is installed.
1000m
2000m
3000m
Stop Print* Stops print operations at the end of service life.
Continue Print Continues print operations after the end of service life.