FujiFilm FF220002 - Page 401

375
Technical Notes
12
Troubleshooting
Problem
Problem
Solution
Solution
The  ash does not  re.
•
The  ash is disabled: Adjust settings (P 178).
•
The electronic shutter is enabled: Choose a SHUTTER TYPE
that does not use the electronic shutter (P 172).
•
The battery is exhausted: Charge the battery or insert a ful-
ly-charged spare battery (P 37).
•
The camera is in bracketing or continuous mode: Select single
frame mode (P 5).
•
The  ash is lowered: Raise the fl ash (P 123).
Some  ash modes are
not available.
OFF is selected for SOUND & FLASH: Select ON (P 274).
The  ash does not fully
light the subject.
•
The subject is not in range of the  ash: Position the subject in
range of the fl ash.
•
The  ash window is obstructed: Hold the camera correctly.
•
Shutter speed is faster than the sync speed: Choose a slower
shutter speed (P 73, 77, 391).