Set the Mode dial to "S".
This is an automatic mode to set the shutter speed.
Use this mode to freeze a moving subject (fast
shutter speed) or convey the impression of
movement (slow shutter speed).
Press "A" or 'T" to select the shutter speed.
• Shutter speed setting
3 sec. to 1/1000 sec. in 1/3 EV increments
,_ @ The shutter speed and aperture setting display @
IOverexp°aed] "c®3[_8 E_+_ _ ' I_N40_
lUnderexp°sed] "r*l[_S'_2,8 _ [±] _j _N4°_
IMetering failed] Ire7 ON 6]
/ @400/
In scenes that are extremely overexposed, the
aperture setting (FS) appears in red. When this
occurs, select a faster shutter speed (up to 1/1000
seo,).
In scenes that are extremely underexposed, the
aperture setting (F2.8) appears in red. When this
occurs, select a slower shutter speed (down to 3
seo,).
When the brightness of the subject is outside the
camera's brightness metering range, "F---" appears
as the aperture setting. When this occurs, press the
shutter button down halfway to measure the light
level again and display a value.
Set the Mode dial to "A".
This is an automatic mode to set the aperture.
Use this mode to have the area in front of and
behind the subject out of focus (large aperture) or
have both near and far subjects in focus (small
aperture).
Aperture
Press 'A" or 'T" to select the aperture.
• Aperture settings
Wide-angle: F2.8 to F8 in 1/3 EV increments
Telephoto: F5.6 to F8 in 1/3 EV increments
_ @ The shutter speed and aperture setting display @
I°verex °sed] ,so4oo/
oco_
Iun orexoesed]
4_
In scenes that are extremely overexposed, the
shutter speed setting (1/1000 sec.) appears in red.
When this occurs, select a larger number of aperture
(up to FS).
In scenes that are extremely underexposed, the
shutter speed setting (1/4 sec.) appears in red. When
this occurs, select a smaller number of aperture.
f_; When Forced flash mode is selected, the slowest available
shutter speed is 1/45 sec.
When the brightness of the subject is outside the
camera's brightness metering range, "----" appears
as the shutter speed setting. When this occurs, press
the shutter button down halfway to measure the light
level again and display a value.
<
"11
¢e
40 41
To Next Page
Loading...
